Water in wash cabinet

Clean the filter combination, proceeding as follows:

• Switch the dishwasher off.

• Rotate the screw thread of the lower spray arm anti-clockwise  (view from above) and pull the spray arm upwards to remove .

• Before removing the filter combination, remove any coarse soiling to prevent it from entering the circulation system.

• Remove the filter combination.

• In order to clean the inside of the filter, pull the microfilter on the plastic ring downwards and away from the filter combination.

• Rinse all the parts under running water.
  If necessary, use a soft cleaning brush to remove soiling.

• Insert the microfilter back into the filter combination.

• Refit the filter combination so that it lies flat in the base of the wash cabinet.

• Refit the lower spray arm to the filter combination using the screw thread.

• 

• Rotate the screw thread clockwise until the arrow in the viewing window points to the lock symbol .

Clean the drain pump as follows:

• Disconnect the dishwasher from the mains. To do this, switch off the dishwasher and then unplug the mains plug.

• Remove the filter combination from the wash cabinet (see above).

• Scoop the water out of the wash cabinet using a small container.

• 

• Press the catch of the drain pump cover inwards .

• Tip the cover inwards until it is released .

• Rinse the cover thoroughly under running water and remove all foreign objects.

• 

• The drain pump (see arrow) is underneath the cover.

• Risk of injury from glass splinters.

  It is especially difficult to see glass splinters in the drain pump.

  Take care when cleaning the drain pump.

• Carefully remove all foreign objects from the drain pump. Check the drain pump impeller by manually turning it. You will feel a little resistance when you turn the impeller.

• Refit the cover by placing it down vertically from above.

Remove any kinks from the drain hose.